Business Networks, Wi-Fi & Structured Cabling

The approach

Infrastructure is a system, not a shopping list.

Switches, cabling, access points and firewalls are usually bought separately and installed by whoever is cheapest that month. That is why so many offices have a network nobody can explain.

01
Designed for the building
We survey before we specify.

A warehouse, a two-floor office and a medical suite need different answers. Walls, ceiling height, distances, device density and how people move through the space all change the design.
02
Sized for what connects
Capacity worked out in advance.

Drop count, PoE budget for cameras and access points, uplink capacity and room to grow — calculated before hardware is ordered rather than discovered on install day.
03
Labeled and documented
The next person can understand it.

Every drop labeled at both ends, the rack laid out logically, and documentation handed over on completion. It belongs to you, not to us.
04
Segmented
Not everything on one flat network.

Staff, guests, cameras and IoT devices kept apart. Better security, and far fewer mystery slowdowns nobody can trace.

What we build

From the service entry to the desk.

Four layers, plus the work that spans all of them.

01

The edge

ISP circuit coordination
Business-grade firewalls
Documented rule sets
Secure remote access and VPN

02

Switching

Managed switches sized to the drops
PoE budget for cameras and access points
VLAN segmentation
Rack layout and power

03

Cabling

CAT6 / CAT6A runs and terminations
Patch panels and IT room build-out
Fiber backbone between floors
Conduit and tray routing

04

Wireless

Access point placement from survey
Coverage across the whole footprint
Separate staff and guest networks
Density planning for busy areas

Across every layer

New offices

Planned during construction, before the drywall closes.

Conference & AV

Display, camera and audio connectivity in rooms that just work.

Surveillance

The cabling, PoE and segment that camera systems depend on.

Continuity

Dual-WAN and ISP failover designed where requirements justify it.

Opening or expanding

Involve us before the walls close.

Cabling routes, camera positions, the IT room, conference room connectivity and power all become dramatically cheaper when they are planned during the build instead of retrofitted through a finished ceiling.

We work alongside your contractor and hand over documentation when the space is finished.

Plan a new location

Finished IT room with an open-frame rack of network equipment beside a plywood backboard carrying punchdown blocks and dressed telephone cabling — **The room the rest of the office depends on** Planned during the build, not retrofitted through a finished ceiling.

In the field

Done once, labeled, documented.

Wall-mounted equipment rack with patch panels, a network switch, backup power and a phone system, beside a fire alarm panel — **Racked, patched and labelled** Switching, backup power and voice in one documented enclosure.

Hand holding a cable tester displaying a lit CONNECTED indicator, with a patch cable attached and an equipment rack behind — **Every run tested** Terminations verified on site before the job is called finished.

Satellite dish mounted on a galvanised mast above a building parapet, braced to the wall with standoff brackets and a weatherproof junction box — **Connectivity where fibre will not reach** Exterior mast, braced and weather-sealed at the penetration.

Remediation

Most of this work starts with someone else's rack.

Nothing here was replaced. The same switches, the same runs, re-terminated onto patch panels and dressed so the next person can trace a cable without guessing.

Equipment rack with several hundred unlabelled patch cables hanging loose across the front of the switches — **Before** No patch panel, no labelling, no way to trace a fault.

The same rack after remediation, with cables terminated onto stacked patch panels and routed through vertical cable management — **After** Terminated, dressed through management, and documented.

Questions

Before you get in touch.

Do you work on occupied offices or only new builds?

Both. Retrofitting a working office takes more planning and often out-of-hours work, but it is most of what we do. New construction is simply cheaper because the routes are still open.

Can you take over a network somebody else installed?

Yes. We start by documenting what is actually there, which frequently differs from what anyone believes. From there we can stabilise it, extend it, or plan a replacement in stages.

Will our internet stop working during the work?

We plan cutover around your schedule and keep disruption to defined windows. For anything that must interrupt service, you get the timing in advance rather than a surprise.

Do you install cameras as part of this?

The infrastructure they need, yes — cabling, PoE switching and the network segment. The surveillance system itself is covered under Security & Surveillance, and doing both together is usually why camera projects go smoothly.

Can you set up a backup internet connection?

Dual-WAN and ISP failover can be designed and configured where business continuity requirements justify it. It is not standard on every installation — it depends on what downtime actually costs you.

The layer everything else depends on.